Plug the USB Sound Card into an empty USB port and connect the headphones to the appropriate connector on the sound card. A single stereo USB sound card can be used to route the audio out the headphone channel. B) 2 SOUND CARDS If the computer has a single stereo output and an additional stereo output is required for the headphone channel. VirtualDJ will then route the Master Output to the 1st mono channel and Headphones to the 2nd mono channel of the computer’s built-in sound card.
Select SPEAKER+HEADPHONE in the OUTPUT options and STEREO TO MONO SPLITTER from the HARDWARE options. Connect the speakers to one of the ends of the Y-Splitter and connect Headphones to the other.
Connect the Y-Splitter cable to the computer’s sound output (headphone jack). The cable will take a single stereo channel (left & right) and split it into two separate mono channels. A Y-Splitter cable adaptor (Single Stereo to 2 Mono Outputs) can be used in this case. Depending on the hardware available, one of the following and most common configurations will generally be required: A) STEREO TO MONO SPLITTER (Y-CABLE) If the computer has a single stereo output, an additional channel is required to listen to both the Master Output through external speakers and a separate channel through headphones. There are many different ways to configure a headphone channel. Settings - Audio Setup MASTER & HEADPHONES The default Audio Setup with Master Output is a good starting point but in order to DJ effectively and be able to pre listen (PFL) to the audio before it goes out to the audience, headphones are a necessity.
0 kommentar(er)
